Recent content by mtec

Lil Foot and sheepfarmer are excatly right! I will make a bigger picture with the planner behind the tractor.

Hi, i did not have a video yet. But in this video you can see for what it is designed. https://www.youtube.com/watch?v=vYPLiQRovgY

Hi, what you can see in that video was developed and contructed by me. Works very well. Of course there is also a additional planing device behind the tractor! https://youtu.be/_Zn0aKH3I0Q

Hi, today i weld the hole in the camshaft and put everything together with new gaskets. I started the engine and had 50 PSI with cold oil (10W30) in idle (may be a little bit high idle), with high rpms i had 62 PSI. Think that looks good. After 5 minutes running it goes down to 40-45 in idle and...

I have that tractor since two years and since that the lamp never goes on during engine run. Last friday was the first time and i stoped engine asap. Should i expect any problems if i leave it in the oil pan (if its there)?

Hi, i think there is a misunderstanding. I did not make a measurement on my engine, i have read that 20PSI and 40-45 here anywhere. I did make the measurement today and found only 5 PSI in idle and 15 with high rpm. I open the gear case cover and found no plug inside the camshaft! Ok, i will...

Hi, does anybody know at which level the original oil pressure switch is working? I have the light coming on with low rpm and want to replace first the switch but i can not see any value on the switch. Does anybody know the correct oil pressure on a D750 engine? I have found aprox. 20 PSI in...

Hi, my Kubota D750 Engine has a Fuel Leak anywhere on the Top of the Injection Pump. I did clean everything with Brake cleaner but i did not realy see where it is coming from. I want to start with removing and cleaning the 3 Fuel Lines, but i dont know the Torque i have to use to install it...

Hi Stepan, you´ve got a PN. Thanks mtec

Hi, i am from Germany and since yesterday Owner of a Kubota B7001. I just discover that one of the four bolts (and nut) holding the Frontwheel on the Hub is lost. I find out that it should be 12mm in diameter and aprox. 32mm length but dont now the kind of thread. Maybe anybody can help me with...