Mr Haney's latest activity
-
Mr Haney replied to the thread Bad Belt Latch.Whitetiger, I can't thank you enough for pointing that out. I must have been crazy, thinking seat belts would be on the seat page. Now... -
might try 2, thin but WIDE bladed screwdrivers. on opposite sides,twist and see if it releases the 'pins' from the 'sockets'. In your...
-
The replacement seat belts are shown with the ROPS.
-
Mr Haney replied to the thread Best Way to Drain Mower Tank?.Mowed the yard today, and the left tank eventually quit. I guess the diesel boogers were too much for Clear-Diesel.
-
Mr Haney replied to the thread Bad Belt Latch.I shot Sea Foam Deep Creep into it. Maybe something will happen. Here are two facts that don't go together: 1) Kubota put 5 safety...
-
How do I open this to fix it? No screws. #Kubota_winning
-
-
Mr Haney replied to the thread What is Messick's Smoking.I used to buy from Messick's, but I have placed 4 or 5 orders recently for my mower, and every time I compared, Coleman's was better...
-
Yup, you indeed missed something….
-
Yes thank you, I know how to use a map and the closest dealer is 2 hours 41 minutes away as I stated... it's a tractor, I live on a farm...
-
We had a storm, so I finally bit the bullet and found a way to run a hot wire to my rear remote "kit." When I got to the fuse box, I...
-
Mr Haney replied to the thread Best Way to Drain Mower Tank?.Wouldn't you know it? I just ran the mower for a while, and it never bogged. Maybe Clear-Diesel ate the booger that was blocking the fuel.
-
Mr Haney replied to the thread Electrical - Wiring Diagrams.ZD326 This is a datasheet I found for anyone who wants to fiddle with their controller and use something else to run the relays. It...
-
My ZD326 appears to have crud in the left tank or the lines that go to and from it. It's hard to get a siphon to the bottom. Is there...
-
Mr Haney replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.I found someone to design a cheap circuit to turn the mower off, and then I tried to use LTSpice to simulate it. Then I gave up trying...
-
Mr Haney replied to the thread Kubota Advice: Buy and Fix up L5030HST, or Get Newer TYM?.Childish.
