Recent content by Mr.Bentwrench

Apparently I did not look at the right part. This just got more interesting. Thanks for educating me.

It has finally warmed up enough that I can think about removing the detent caps and checking them out. I have fine motor skill issues now, so I'm wondering if any small parts are going to take flight when I remove them. Looking at a parts diagram, all I see is a spring. Thank you.

Since the temp dropped below +10 the other day, the joy stick on the B3030 wont curl or uncurl, (wont move and am afraid to give it a lot of force) and the boom direction will move with a lot of force. I believe it means water in the cables, but how can they be dried out? -5 here this...

Gonna see if they are available online. More fun than a hole in a nightgown!

I've always called them piscuits, but it never caught on.

I tried the ATF-Acetone mix, and it wouldn't stay mixed. Stored it in a translucent plastic squeeze bottle labelled for Acetone use.

This is as fouled up as a football bat

Somebody will still be able to motorboat!

There was a time after our third child was born, and I broke my leg, that the squirrel helper would have been downright handy. 2cents for a .22 shell and 25cents for a can of wop biscuits made a squirrel pot pie for the family.

Hi guys. I have two issues that I need to address, The tractor is a B3030. The first is that I have managed to shatter the lh door. Is this a pretty straightforward repair, assemble it on sawhorses and then put on tractor? anything special to watch out for? The other is changing the...

So, are you putting the neversieze on the threads, or on the taper where the nut seats in the rim, or in the case of lo-boy rims, on the flat that meets the clamp? I just put some new clamps on a low-boy installation, and the difference in number of turns between old unplated and new plated...