Recent content by modeladay

Thanks, the hard part is getting to the pump. I’m going to remove the loader to mac things more accessible and that’s a pain , at least for me. The radiator also looks like it needs to be removed. The price of an oem pump is$240😡. After market are as low as $36. Aftermarket pumps very in price...

What are your thoughts on non oem water pumps? Chinese I assume.

Fan is flopping around on the water pump , I assume it’s bad🙂 I’m guessing the radiator will have to be removed to to get to the old water pump? I’m getting to old for this😁 any suggestions will be much appreciated…thanks!

Georgia clay, had to bury a horse, the hole was deep enough to bury the whole tractor 😁

Ready to work 😁

The inner seal was soft I pinched in in the manner you described and it went right in. The so call dust cover was hard, no way in hell could I get the new seal in. Well I’m an idiot, I didn’t realize the metal rim of the old seal was still there. (Yes you told me this, I just need to read...

I’m not sure I know the difference, however you can’t pinch it out of shape

The dust cover seems to be really rotten , its just coming out in Pieces and Its almost as its glued in. ( metal ring was still in, my bad, I need to read better)The parts diagram shows the seal( gasket) being inserted from the plate cover side . But the needle bearing needs to come out to do...

Dave you knew I would be back, how does the needle bearing come out? I have tugged on gently and it did not move. also the outer dust cover is just coming out in pieces. My back give out about half way through and I give up on it for today. Anyway if you can tell how to get the bearing without...

Good suggestion, I looked and there is nothing on the seal😞 will I have to dig this seal out or will it come out easily? I would like to pull it out in one piece just to eye ball it and look for where it failed.

What concerns me is its not as beefy as the dust cover. I’ll start so, at least right now its not as hot as hell

Dave here are the photos of the part, the gasket 130 and the outside dust cover are similar . The dust cover is heavier in design.

I will do that

Just as a follow up I removed the loader today, I’m still waiting on parts its been over a week😞 I’m wondering if they’re having a hard time finding the so called gasket? Don’t want to disassemble until the parts get here because it will take up space in my garage. I’m going to try and do this...