Recent content by Mikec575

Makes perfect sense and reiterates what I was thinking. Thank you

I have a L2600 that the arm on the shift broke off and I am trying to figure out the purpose of the ball and spring? And how do you assembly it without losing the ball and spring in the transmission? Sorry I have always wanted to know why and how something works

Yes sir that’s fine and I can get two short hoses made to fit the nipples on the tractor.

Yes sir that would be money well spent for me. So I would just need 2 short hoses to hook to the male ends on the tractor

Yes sir that

I have a bucket that has all types of fittings and just hoses laying around but nothing organized. I can just buy everything new I need for this that way I am not spending timing trying to make stuff work.

Are you referring to the fittings under the right foot plate. I have one of the loop pipes that fits it so I can just take that to my hydraulic hose guy and see if we can’t make something to hook my gauge too. There is a second discharge pipe coming off this pump so would that be deadheading? Do...

So cold the pressure is 1600 and hot oil the pressure 1300.

I only tested it cold. Yes sir I was around that 2200 rpm when getting that pressure. also did I mention I swapped the relief valves just to rule that out as well. The 7040 relief valve didn’t seem to increase pressure when trying to adjust it so I just took the 7060 that has good pressure and...

Sorry I didn't mention that earlier. When I have mentioned about a new pump or part everyone always says you still need to test the pump

I am up for the work. It's having the knowledge to do it without deadbeading and damaging the brand new pump.

How can I go about seeing if it is bypassing in the steering system? I am only getting about 1300 psi at the rear remote. I took the hoses off the rear lift cylinders and there is no fluid coming out of the cylinders.

No sir I do not have a loader on it

My M7040 3 point will pick up implements in the morning and after lunch I have to bring the RPM up to get it to lift the same weight it lifted before lunch at an idle. any suggestions? comparison- M7060 will lift the back of my gooseneck no problem and the M7040 barely lifts it when bringing...