Recent content by Mike Harrison

. 20mm

Had the injectors tested new seals on the head I checked the valve clearance before I took the motor apart. The clearance on the valves was .14 when I reinstalled the valves the dealer told me to set the valves at .20. I have fuel at the end of the hardline just before it hits the injectors OHM...

I just installed new pistons and ring. Put everything back together but it wont start. I have white smoke. (It tryes to turn black ) I set the vales at .20 crack the fuel lines (one at a time) at the injectors. I have fuel but not much pressure. just a note i had the head and injuctors done...

Thanks for the help. exactly exactly what I was looking for

Can everyone tell me what the ring gap should be set at? Also what should the tolerances be on the Rod bearings?