Recent content by MD2595

It was on the magnet when I removed the filter. I manipulated it with my finger to see it from another angle.

I had an incident at about 60ish hours and the leak was fixed and the fluid/filters changed. This hose went at 432 hours and I lost most of the fluid so another fluid/filter change was done at 432 hours.

The hydraulic oil was changed at 62 hours and it only had 432 hours on it when this hose busted and I replaced the hose and did a filter/fluid change.

Haven't torn into it yet. I probably won't until there's an issue with operation.

At about 60 hours I was using a PTO mulcher and it threw a limb into the belly causing a huge hemorrhage. I immediately stopped the tractor and had a friend look under it while I bumped the starter. A banjo type fitting had come loose and that's where it was spraying from. I tightened up the...

It's a gear tooth. You can see where it fractured off the gear.

It's definitely some sort of gear tooth.

It is not.

I have been able to take pics. Sorry for the delay.

Great. Should I be worried???

My M7060HDC12 has 432 hours and I blew a hydraulic hose (cheap factory Gates) and since my tractor is almost 500 hours, I went ahead and did a hydraulic fluid/filter replacement. When I took off one of the filters, this piece of metal was stuck to one of the magnets. It kind of looks like a...

I found exact replacements, but they aren't cheap. Almost $4,000 for all 4

Just west of Shreveport, LA

Where are you located?

I'm worried that the taller sidewall will cause clearance issues.