Recent content by mattillac

Found these online, they look similar to what you have there. https://www.hatchlift.com/brackets-hardware/endf-10 Seems as though, amazon sells the same as above and similar. https://www.amazon.com/uxcell-Female-Thread-Fitting-Connector/dp/B07CMXLYVV?ref_=ast_sto_dp Stumbled upon these as...

Think safety, some might refer to that as the "first" attachment(for good reason). Adding the necessary tension to raise that line while standing on a ladder could result in you pulling yourself off the ladder. That wire was most likely originally attached to the house "first" when there was...

I am new and just comparing images. My guess is a L2250 https://www.youtube.com/watch?v=YjdqtmnVTps

A few more pics.

Thanks for the pics etc. I wound up ordering 70000-72900 which came with 70000-25040 blades. Took under a week to get, and a hour or two to install. Ran the mower to make sure it sounded good. Will try and mow some grass next week. Peace. :D

Hello there, new guy here. Hoping someone could help me out, I am looking for a Mulching Kit(if there ever was such a thing)for my RCK48-15BX MMM. Any help would be appreciated. So far I have been using regular blades with the side discharge and have been satisfied, except for having to...

Installed boltonhooks and clevis mounts on my LA181 / BX1500.

Could dude have cleaned the filter, like blew it off/out with compressed air or something ?

New guy here, know very little about the subject, found this here though; http://www.boltonhooks.com/kubota.html Those are on the bottom of that page there under "more pics" Maybe one pic shows them centered and "halfway through the bottom lip" and the other shows them placed slightly...

New guy here. Just put the (new to me) BX1500 tractor and LA181 FEL to work, removing 6 to 8" of wet/heavy snow from our gravel and blacktop driveway. Put the snow right where I wanted it and didn't break a thing. Good times. :D

BX1500, installed two new/used front tires and rims. Got them as take offs, it seems as though they had been taken off of two different year tractors though, lol. :rolleyes: Tires are the same size/brand etc, yet they are about 1/2" different outside diameter. IIRC one rim was marked...

Thanks for the info. It looks like the paint I threw on there is a decent match, probably not close enough for touching up smaller chips / spots though.Probably going to be near impossible to match perfectly considering the sun fade. Maybe in the spring I can take more time to remove the loader...

Thanks again for the warm welcome. Went ahead and brushed some oil based rusty metal primer on the inside of the bucket, outter sides and bottom. Primer is still a little wet there, going to try and roll on some Ace brand Allis Chalmers Orange later this evening and see how it looks.

Thanks much. Chicago area here. :) For now we are being extremely careful and taking little baby steps. Am looking forward to putting it to really good use. Thanks again