MartinmMc's latest activity
-
MMartinmMc replied to the thread B8200 no hydraulics.If this is the correct position, still no pressure
-
-
MMartinmMc replied to the thread B8200 no hydraulics.I've painted where roll pins should be & the pointer
-
-
MMartinmMc replied to the thread B8200 no hydraulics.Sorry, I've been away working. I've checked the valve base & there is evidence of 2 pins. I have set the pointer on the stops & it's...
-
MStart finding a gear case for the hydraulic drive before it comes completely unglued!
-
MMartinmMc replied to the thread B8200 no hydraulics.It's 10.30 here in the UK, so I'll update you tomorrow. Many thanks for your patience 🙏🙏 Martin
-
MThat is not a bolt - it is a valve stem. It is supposed to rotate but there are supposed to be two more roll pins in the surface pointed...
-
MMartinmMc replied to the thread B8200 no hydraulics.Hi Dan I owe you an apology about schematic for the hydraulics, see amended sketch. Also another pic of the outlet block , the bolt...
-
-
M@MartinmMc - - You're fortunate to have Dan (@TheOldHokie) helping you out. Couldn't count how many times he's helped with...
-
MThe outlet block is the one up by the floor boards. If your remote valve dumps into the top of the transmssion case this may have...
-
MMartinmMc replied to the thread B8200 no hydraulics.The circled area is the a return flow into the top of the transmission case, I think you were referring to it as the tank. What is the...
-
MMartinmMc replied to the thread B8200 no hydraulics.Yes I've stood on the arms
-
MIt does not matyer. The arms came up so the pump is working. Check and confirm the position of the selector valve on the outlet block...
-
MMartinmMc replied to the thread B8200 no hydraulics.The direction valve rotates, but doesn't have stop, just rotates I've redrawn the hydraulic flow circuit
-
-
MMartinmMc replied to the thread B8200 no hydraulics.No load on the arms
-
MMartinmMc replied to the thread B8200 no hydraulics.Hi Dan, The valve under the seat is apparently used to slow down the lowering of the hydraulics, that's what I understand it's for...
