Recent content by mandkole

I've got a bearing/seal driver set but these are very tight fits. I've thought about the all thread method, and the shaft for the double sheave on the deck has a tapped hole in the end. Considered using a piece of pipe with a cap and all thread to draw it on.

Doing a complete service on the deck of the T1460. Using a steering wheel puller, I got the 2 sheave drive assembly off the shaft, and the gear puller got the bearings out of the blade spindle housings and the deck shaft. My question is how does everyone get them back together? It appears...

Right under my nose-- thank you!

hello, First time poster-- 1)Doing a first time belt replacement on the 40" deck for the T1460. Anyone have the part numbers for the motor/hydro belt and the deck belt? They can't be ID'd since the idler wore the PNs off. 2)Need the thread for the bolt that holds the blade to the spindle...