Recent content by madbarney

Does anyone have knowledge of the k series 3 point backhoe? I am trying to figure out in and out flow on the backhoes control valve. Also, required pressure needed to operate effecvtively. Thanks in advance for info related. madbarney:

I have a B8200 I was wondering if anyone knew the bolt sizes for the loader mounts on the engine. I am in the process of installing a Loader with Quick-attach and I am not sure what the bolt sizes are. I am guessing that they are about a 12-14 mm bolt. But, I have no way of knowing the pitch...

I have a B8200 I was wondering if anyone knew the bolt sizes for the loader mounts on the engine. I am in the process of installing a Loader with Quick-attach and I am not sure what the bolt sizes are. I am guessing that they are about a 12-14 mm bolt. But, I have no way of knowing the pitch...

I found a sizing sheet on Hoseandfittings.com under ultimate sizing sheet. I was able to match the plugs in my hydraulic block as BSPP 3/8" or 06, whichever you prefer. I also called Kubota and they confirmed that Power Beyond on the loader valve hooks to Neutral on the hydraulic block. So, to...

Wolfman, i was wondering if you saw my last post 3 days ago?

Hi Dusty. Maybe you can call Northern tool Parts Department at 1-800-222-5381 to get the PB plug.

So Wolfman, do i hook the PB/C to neutral on tractors hydraulic block(the three point on the tractor is already piped from the factory from the hydraulic block on the tractor to 3 point area) The ports I want to tap into are extra on the tractor's hydraulic block and are currently factory...

My loader valve(open center) has three ports: P, T and C. I believe C is for power beyond. My question is, on my hydraulic block, I have three ports: Pressure, Tank and Neutral; do I have to use the neutral port on the block or can i just leave that plugged. I do not need PB so should I leave...

Thanks Wolfman. I'll look into this.

I thought that area was for power steering. I was wondering about #37; there are three of them. They are shown hooked up in Aerollands post with North Idaho Wolfman from 4-28-15 under hydraulic failures. It was a 3 day post 4-27-28 &29 of 2015. Thanks

I have a B8200 hst-d; D950-A-DT diesel. I am not sure of s/n but I see on transmission the #'s B8200-HD- 61250 can't read engine s/n but there is a d, 5, and 44370 I can see. I am buying a#45463 Nortrac monoblock 2 spool 500-3000 adjustable relief w/12GPM flow rate SAE 8 ports. I don't know the...

Hello everyone, I am new to this forum and am trying to learn how to navigate. Can you guys tell me what the sizes are, for the hydraulic ports, on the hydraulic block, to hook up a FEL on my b8200? You know, the three plugs on the side. Are they the same size and do I need different type and...

Re: Hydraulic Failures - - - RESOLUTION Can anyone tell me what the sizes are, for the hydraulic ports, on the hydraulic block, to hook up a FEL on my b8200?