Recent content by lilorange

thanks everyone ill look thru them all to triple check.

Thanks but they have operation but no service or repair manuals.

I've read a few post on where is a good place to purchase service and repair manuals, but nothing solid. Ebay seems to be the best but was hoping to find a digital copy so I didn't have to wait a week for the book. Does anyone have a good place or should I just go with Ebay or amazon? I'm...

yea it shows how they all line up. Was talking to a local guy and he said they only line up around ever 80 to 100 turns. Not sure if that is true but it make sense because after turning it over 10-15 times its not close at all.

Working on replacing the governor-throttle levers and need some assistance on how to align the marks up on the four front gears. There are 4 sets of marks 1 dot, 2 dots, 3 dots, and 4 dots. I've turned the engine over about 5-6 timing and not able to get any of them to line up. Do I keep...

Thanks and after getting timing cover off all looks good inside from the front. The governor lever is still very low even after its all the way against the front gear. I then try to just bend the governor arm back up and it started to align or go high enough in the rack. This leave me to believe...

Thanks for the info!!

I got a L3010D HST from a friend a couple years ago because it had no throttle and would run wide open. I starting taking covers off to inspect the injection pump rack to find out in was off the governor arm (seen in the first picture). In the picture you will see no springs but they have been...

Well i pulled off the speed control cover and the spring it attched. I also fail to mention before that the govenor arm even with force wouldnt go up far enough on the rack. This leads me to believe the govenor arm is bent or somehow out of position. The only thing keeping me from believing...

Got it appart and the govener was off the rack so i said awesome found the problem. I when pulled the rack back and lowered it into the govener slot. The issue I still see is in the attached picture the govener still gets knocked off by the emergency cutt off if pulled. It seems the govner arm...

Yawl are correct there is a Stop lever cover. Ill start working with it over the weekend and post finding. I also just found out that it was worked on just after he down it so working over someone elses work could be fun. Thanks guys for the info its very much appreciated!

I have a L3010D believe its a 2000 (S/N 82767) that runs away. I got it from a friend and been sitting for about 2 years. Im pretty sure the rack is stuck in the pump but didnt want to pull it out before posting. When i first started It figured it was just oil in the cylinders but it wouldnt...