Recent content by ldozier

Well it was the weekeend and nobody was available to look at my tractor. I needed it Tuesday. I put 16 oz of Lucas deisel injector cleaner in 4 gallons of deisel and let it set at fast idle for 2-3 hours. Better but still some smoke at light load. I put 16 oz of Hotshots in 4 gallons of deisel...

Kubota told me no shafts were available however they had a few of the complete clutch packs available for nearliy $5000 which included the shaft and the flywheel insert. Add a few gaskets and tax, about $6000. No apologies. noteven a dealer discount from corporate or the local dealer. I needed...

Why would an injector go bad at 2000 hours?

This after noon blue/white smoke. New fuel filter. new air filter. drained fuel tank and added new fuel. Perhaps a plugged or bad injector. Anyway to test them? How hard is it to change an injector? Can I take the fuel line loose at each injector and blow through it?

It has 1950 hours. this morning it warmed up and the clattering quit. I used it about an hour harrowing with a few intermittent bouts of lighl clattering and white smoke. This afternoon heavy blue white smoke.

My Mx 4700 idles fine but stared clattering and smoking under load. I havechanged the fuel filter and changed the fuel

Sorry to be so slow reporting back. My MX 4700 is running great. I don't know if I had some residual bad fuel in the lines or just took a while to clear all the air in the system. Over the course of a few hours I let it idle at low speeds then at higher rpms. I used it lightly. occasionally...

I ordered a new fuel filter. Drained the tank and poured about a quart of kerosene thru then about a gallon of fresh fuel from a busy station. I installed the new filter with new o-rings. It fired right up and sounds good at low idle but it is worse than ever at 1500 rpm. No power, smokes a...

My 2013 MX 4700 with 1140 hours is losing power, emitting white smoke, and the engine clatters under load. I changed the fuel filter and air filter and that cured it for several hours of operation. The problem returned so I drainedthe fuel tank and blew out the fuel ines. Problem solved for a...

The mechanic got it apart and found the input power driveline had stripped the splines.. anybody know where to get a replacement shaft?

My L3650 with a wet clutch just stopped moving. The engine runs, all hydraulics work, all the gear shift and clutch pedal feels normal but nothing moves when the clutch is released. Obviously something came loose in the internal drive. Any one with experience or where can a get a repair manual