Recent content by lakemathews

Wow, I'm done with the dealers, thank-you I didn't notice

can this be converted over to inches so I can get new ones

Dan thank you very much for your help , I will be in touch after I install the new cylinders

OK the top pin is 2inches The bottom is 2.5 inches

The top pin is 4inches wide The bottom Pin is 4.5 inches wide

OK Dan Extended boom cylinder with bucket up all the way is 43.5 inches from middle of Pin to Pin Rod is 1.18 thick Boom outside diameter is 2.2 Boom retracted on ground from middle of pins is 27 inches with bucket on ground d

OK Dan, Rod is 1.18 Bore is 1.2 Retract is 29 inches Pin is 1 inch Pin to pin is 27 3/4

Ok The boom cylinder od is 2.19 The boom piston is 1.18 Do you know the part number for the lift cylinders Thank you for that info

Good morning Dan Here are the specs Bf300 loader 17.9 inches reach (dumped) 45 cm 47.4 inches reach (ground) 120 cm 23° rollback 79.1 inches height (at pin) 200 cm 64.4 inches clearance (dumped) 163 cm boom cyl: 1.77 inches 4 cm boom rod: 1.18 inches 2 cm bucket cyl: 1.77 inches 4 cm bucket...

OK I'll get busy

I'm kinda done with the dealer, just spoke with kubota hement and they don't rebuild them anymore, just basically said good luck,

Hi Dan, Keith here 300 loader and I would like to replace all of them

Hello everyone Was wondering if there is after market hydraulic cylinders for my loader on my b8200d