Recent content by L3902dotido

Yes to holding valve open. Rpms are wot and I'm trying to bump it and do when you get it to read more including tapping gauge.

Oh I'm just piddling. Was trying to see if I could get a more lift capacity. I'm still trying to wrap my head around why this reading is so low. It's the 526 loader. Seems like the gauge is bad or I'm getting pressure relief way early. Spec on this machine is and around 2700 or something. It...

Was still low on other loader port. Seems to be where most people test? Bad gauge?

would quick connection to the bh77 hose be the same thing?

Am I doing this right? Reading is very low!

I'm in the process of draining it. Pretty upset about it but don't think there is anything I can do or can be done about it. First service on it was supposed to be at 800 hours. Wouldn't have guessed it wasn't filled up from factory! Shame on Kubota for not filling them up at the plant, shame on...

So....my L3902 is coming up on 400 hours, was getting ready to service it, decided to check front axle fluid level after thumbing through the manual, was VERY LOW. I quit counting pumps around 50 strokes from my five gallon buck pump. I'm not sure how low it was, but was clearly not filled up...

They were reversed it's fixed

The screenshot up side labove shows the bh77 female coupler as the outlet hose. It should be going back to the block under foot rest. I've got my loader hose plugged in there in to the female end on hoe

I think I've got my hoses bass ackwards

Is the short female coupling hose on bh77 the "in" from loader? Then the loose longer make on bh77 the return? 3 point is all the way down, but the factory does have a stopper there I could remove to push it down further.

Guns try to write current routing clearer. Loader pb port 10 foot hose with make quick disconnect plugged into female on bh 77. Male bh77 (long lose hose) going to hydraulic block under footrest

I think I might have my hydraulic flow reversed on my new to me install L3902/BH77. The stabilizers don't go up and down just wants to go into overpressure sound and I can't lift the boom. It seems to want to extend though. I made a long hose from power beyond on loader and put a male end in...

I was taking about free play side to side in implement, guessing you can have an inch with the bars be 0 with the buckles

I've been looking at the stabilizers pin type vs turnbuckle. It looks like you would have more slop or free play in the notched kind. My tractor came with a quick hitch with the turnbuckles cinched down so it doesn't have side to side free play hopefully it is set up right. I'm a little gunny...