Recent content by Kubotajoe15

Was the valve something like this? I am wanting to add a 3rd function to my FEL https://www.northerntool.com/shop/tools/product_200329586_200329586

Sorry hurleyhuckster I have been super busy lately, but yes my 3pt doenst start raising till ~4 of the number scale and yes that is annoying but I have just been running with it. Also I noticed my FEL is quite crooked, like 2"+ off when one side is touching, Let me know if you find out anything...

Update, New block arrived today and I picked it up on lunch. I took a pic of them side by side and you can see the difference is not that much. it looks like the tube was welded in the first one backwards. I complained that the new one (Left) wasn't painted and the old one was so he threw in a...

Thank you for the pic, that looks similar to the one I have, its a tight area for sure. I will take a pic of the one I have and of the new one when it arrives and compare them. If possible I will set them side by side at the dealer and snap a pic.

Thank you. also Let me know what they find out about that valve, I may have a similar issue also. I moved 34yds of gravel doing my drain field and I thought I noticed the bucket starting to dump a little slower but just thought maybe that was break in or maybe I was just crazy or something since...

So I bought the valves from a different dealer than I bought the tractor. (whole other story) and I called both dealers today. The dealer that I bought the valves from was so small that they haven’t even installed any of them yet, thus the reason for calling the larger dealer I purchased the...

Well I Called the dealer and talked to the service guy and he said there is a known problem with the B2601 and the rear remotes. He said they are working on a fix but for now if I want to put them on I will have to modify the feedback rod. He said he normally bends the rod out of the way and re...

Top and Tilt is the main reason I ordered them also. A few pics would be great. Thanks

So I picked up a set of rear remote valves from the Kubota Dealer ($1113 otd ouch) and I went to install them and the block that they provide to mount the valves to the hydraulic system interferes with the 3 point feedback rod. I dont know if anyone has ever heard of this or if this tractor is...

I did find one before picture of it when I got it.

A few more pics, I got it all assembled and painted up and it works great. one bearing is a little noisy but I gave it several pumps of grease and I plan to run it till it gets a little sloppy and then replace it. as you can see in the one picture the deck is pretty pitted. I gave it a good wire...

After taking it all apart, I bead blasted the case inside and out, it looks much better now. (I didn't take pics before I'm bad at pics) I installed the new bearings and seals, polished up the rusty gear as best as I could. I reassembled it with some engine assembly lube. I painted it Kubota...

Actually this looks exactly like it. but I would rather not buy a new unit. Now if i can find parts. Hopefully its ok to post ebay links http://www.ebay.com/itm/SCAG-482486-Deck-Drive-Gearbox-Assembly-Genuine-OEM-/251920773252

That gearbox listed looks almost exactly like what I have except i have the older model with the output shaft and gear all one piece. I don't have any pictures right now, but I finally got the gearbox apart after heating the pulley mount and the pto yoke to get them off. I took the bearings and...

Got it from my uncle. It’s an Allis Chalmers Model 63. 5' 3 blade mower. It has been sitting for at least 10+ years, I got it home and after a little lube I got it hooked up and to my surprise it still works till the next day when I went in to the garage and there was a quart + of gear lube on...