Recent content by KubotaAlex

Dealership ended up coming to pick it up two weeks ago and was not really clear on what ended up being wrong when I called to follow last week. It sounds like they assembled it wrong. Two weeks later, I’m finally getting my tractor back today. Hopefully the guy dropping it off will have some...

Looking for some advice, see below video. When following the proper procedure for removing the FEL on my 2023 LX2610 with 35 hours i am only able to easily remove the left pin. The right pin will rotate but requires a lot of force. I am on a level surface in my garage. I noticed if i put a 2x4...

Shaft length seems perfectly fine. With the hitch all the way up there is still about 1.5 inches before bottoming out. I can almost remove the shaft from the tractor with it fully raised. I think the angle is the issue. And yes, I don’t need to raise it that high but it is much easier to not...

Good points. That does make sense. SB1064 Manual says not to exceed 25deg it seems like I am within that limit but still having that issue. Maybe I need to break the protractor out, lol. Thank you for the insight!

Hello, I have an issue on my SB10 blower I can’t seem to diagnose. Snowblower operates normally unless it is raised to above “7” on my 3-point control lever. Around 7 there is a loud rattle from potentially the gear box or auger. If the hitch is lifted any higher it will shear the PTO shaft...