Recent content by KubBRC

Phildac, Thanks for all your help. I bought a regulator from Ebay and that took care of the problem. The charging light went out and the voltage was 13.5 and climbing. I did not run it long as since I removed the gas tank there was not much fuel in it. The thing is though, I checked the blue...

Service Dept. Vic. I have attached a link to ebay that has a regulator to fit my B8200HST. The problem is I see an un-attached Black wire. I am concerned it may have gotten cut while opening the package. Is this simply a ground wire to be attached to the body or frame or should it be connected...

Phildac, Thanks so much for all the information. I have a local dealer nearby and will check with him on the regulator first. I like to help our local folks first, but if it is just too much above ebay, then that's where I be headed. Thanks again for your quick response..

Phidac, I checked out my dynamo and it is charging. After removing the tank and loosening the dash, I found the regulator/rectifier but mine is a RS 5101 and does not have the wiring to the plug as you show. I have the six wires but on one side there is a blue black blue and on the other a...

Thanks Kubota Newbie, but I plan to try Phidac's suggestions first. If they do not help, I will take it off and have it checked.

Thanks Meanjeaan but I did that first thing and it did not help.

Hi everyone and thanks for you help. I have an older model B8200HST. It is a 4wd unit and it began showind the no charge idiot light last fall. I recently checked the voltage before and after the engine was running to find the remained around 12.4 volts.. How do I determine if it is the dynamo...

Hi, I have a B8200 HST that is not charging. It has a pretty new battery so it will run. I tested the voltage before and while idleing, at the battery posts. Basically 12.4. Where is the voltage regulator and how do I test it to verify if it or the alternator is bad. Actually, it is not an...