Recent content by Keystone B7300

I got it to finally work. Just hoping this helps someone out. Just basically kept trying. I took the rubber hose off the pump but left it connected to the pipe and by doing this let the air escape in the line. I then syringed fluid into the actual pump and quickly closed it back up and started...

Or is there any other troubleshooting ideas? I can't get fluid to follow well though #40. Even though the screen is clean

Well put the UDT in it, replaced o rings, double checked the screen, took the hose (#70) off and inspected it. I took the rubber hose off the pump (#70) and used some small tubing and a syringe to put some fluid in the pump to "prime" it. It seems that the pump is bad. I just don't get that it...

Thanks I understand. Should have gone with the right stuff from the beginning. Picking up the o-rings, Kubota UDT and a new screen just in case tomorrow. I'll have it put back together this weekend.

Dave thanks for the reply. I will fully drain the remainder tomorrow. I only ran it short bursts while trying to troubleshoot. It does seem like maybe the fluid might be too viscous. Can you recommend a good UDT fluid (Valvoline?), or just Kubotas own brand? I'll try to get some fluid into the...

So I searched for an answer to my problem but I couldn't find it. The tractor in question is a B7300 HST around 750 Hours. I hope someone knowledgeable can help me with this. I recently changed all of the fluids, filters, and cleaned the screen on the banjo bolt and the 3 point hitch functioned...

Also, Thanks for the help!

Hey everyone, So i'm in process of replacing the head on my B7300 (D722 engine). the old head cracked in the rear (towards driver) behind a set screw/plug. I was looking at welding it, but decided to just replace the head. I looked at my local ACE for a replacement plug and couldn't find a...