Recent content by kenanb

Did you go with the factory setup on the L3830? If you did how do you like it? Could you possibly post a picture of the finished project? Thank you.

Hello. I am going to install rear remotes on my L3800. I really like your setup! I want to ask how the valves are working for you. Is there any internal leaking? Would you use the same valves again? Would it be possible for you to post a couple of pictures of the completed project that shows the...

I did check my pressure yesterday. It was 2,400 PSI at about 2200 RPM. The RPMs did make a difference - PSI increased some with RPM. I did not consider the air temperature - The air temperature was about 38 degrees. The tractor had only run about 10 minutes when I checked the PSI. I did locate...

Thanks to both of you. I am going to check the pressure before I proceed.

Hello, I am new to this forum. I just took delivery of a L3800 DT with a LA524 Loader. I also have a L245 DT with FEL that I have used for years. The L245 will pick up as much weight as the L3800. I want to increase the pressure on the LA524 loader. Can anyone tell me how to do that on the...