Recent content by jt2hunt

Latest update. I reinstalled the pressure relief valve. I then screwed it down as far as possible. I measured the flow and I am getting a gallon per 20 sec. 3 gpm. This is at low idle. I put the coupler back together and started the tractor. 3 pt hitch moved and fel is working. Not sure...

I did what you mentioned above. I do have flow, not sure how much. When i throttle up, the flow increases but not enough to cause a mess as it is directed into the fill port. I suppose I could get a gallon bucket and time how long it takes to fill. I remember something that may help. When...

I will not be able to work on my tractor until this weekend. I did get my pressure gauge.

Yes orings are back on. Yes I have flow at fel, but I am not sure how much flow it should be from just eyeballing.

Yes the coupling pictured in the circle. I replaced the coupling, two bearings, and the cap. No leaks because the transmission and steering are working. I suppose it could be something inside the pump itself. Once I get pressure gauge then I can test in certain areas and see if we build...

Thank you for the information. Still waiting on the pressure gauge to arrive. Some more important notes that may help to diagnose the issue or point me in the direction to look. I had been moving dirt for several days. I had recently added hydraulic fluid and after the failure the dipstick...

To answer the question about working properly. Yes, it was working great and stopped after using it for an hour that day.

My fel and 3 pt stopped working. Thought it may be the coupler on the front pump. Changed that out and still not working. I am getting flow to the inlet hose that connects to the husco hydraulic controller. If i take the outlet hose off, the flow is much less. I checked the detent assembly...