Recent content by Jsjac

I is also a red neck hillbilly

Does the hole ho all the way through the aluminum? Could you use a longer bolt and nut?

I have seen early pictures of parts of New Hampshire and there are no trees. New Hampshire was 85% clear farm ground,no trees. Now it is 86% forest/timber land. The numbers might have changed a little bit since I looked at them roughly 20 years ago

I have been wanting to move my small wood shed for a while. I need to get the 2037 wood under cover soon. I brought home a load of 3 inch stone in my dump trailer and leveled behind where the shed was. The shed is on the skids ready to move. op Now it is in its new location and all leveled up...

You might also check the bushing in the front section of the pump. Maybe the pump has a little bit of shaft play.

Looks to me like it broke at a pin or bolt hole. Not much metal outside the pin hole. Maybe a ¼inch. If the ground is rough that would put a heavy load on that. Especially a side load. Five years is a lot of mowing. Check the other one.

I did find a satchel full of letters the 1920-1940 in German. I want to see if I can find someone translate them for me. There was also a bunch of German bear coasters also

Find anything good? We have been cleaning out my parents place. So far 2 thirty yard dumpster. Mostly just stuff. Used lumber, decorations and lots of gardening stuff.

If there is enough space I would put two cla.ps per end

Are they factory fenders or an aftermarket setup?

I have had a few different trailers. Mostly used for work. I have had deck over trailers and low profile trailers. Now I have bought a tilt deck trailer that has 23 feet of deck. 18 feet tilts and 5 feet at the front is fixed. So far I like this trailer the best for moving my tractor around...

No wood processor yet. Just a saw and splitter. A friend said he would drop off his processor but the log pile is just about done and told him it is not worth it at this point

I brought my tractor to the shop for a spring oil and filter change. Also power washed it and a quick vacuum and blow out with shop Air. This is coming home tonight.

I removed the chains and snow blower from my tractor today. I tried to spread some dirty today but it was still to wet.

Looks like lots of good firewood to me