JRHill's latest activity
-
JRHill replied to the thread hydraulic line repair ..No. -
All those numbers! You apparently weren't in the Marine Corps... 🤣 Hold the stick in one hand, paper towel in the other. Press the...
-
Look again, those lines before and after are "1", so it reads 15371 36411 -- the Kubota part number for that dipstick.
-
JRHill reacted to Lencho's post in the thread Post hole digger for a B7100 - ROPS clearance is 2.5 inch with
Like.
It is a bit long. I have no problem digging and can dig at idle. Lifting power is what limits me, so I lift every foot or so. -
JRHill replied to the thread Post hole digger for a B7100 - ROPS clearance is 2.5 inch.If you need a ROPS you do a ROPS. The best is to never go or do something that you need a ROPS. But for people who don't know about...
-
JRHill replied to the thread Main 9 wire connector B7100HST old.When I rewired much of my B7100 last year I had the same problem with that and some other connectors but the deterioration was mainly...
-
JRHill replied to the thread Post hole digger for a B7100 - ROPS clearance is 2.5 inch.@Lencho , those are some pretty beefy rears. Where did you find the wider rims? Sorry for the tread drift.
-
JRHill reacted to North Idaho Wolfman's post in the thread Post hole digger for a B7100 - ROPS clearance is 2.5 inch with Like.
B7100 are mighty little beasts! They can handle and run equipment that other tractors their size can't touch.
-
Gloves: I usually end up with all lefties or all righties when I really need them. Because I have dogs. Dogs love gloves, because...
-
JRHill replied to the thread FEL while mowing..I like to leave to loader alone and not mow. ;)
-
JRHill replied to the thread What did you do to or on your Kubota today?.The only accurate fuel gauge I've ever had in any machine was a stick.
-
JRHill replied to the thread What did you do to or on your Kubota today?.Fixed a broken zirk on the BH bucket. Threads are wiped out on the cylinder so plugged it. Drilled and tapped a new hole where the zirk...
-
JRHill replied to the thread What did you do to or on your Kubota today?.Got an 18v grease gun. Darn that thing works good.
-
JRHill replied to the thread What's cookin' boys?.Couldn't quite finish up a lamb shoulder roast in a stew. Lamb is hard to find around here.
-
JRHill replied to the thread B7100 non-HST dipstick.I've only had this machine for 34 years and it was 15-20 years old when I got it so I thought I should figure this out. Especially when...