Recent content by JrExplorer

I have a question. With the reverse flow for the BX cooling system how are you going to keep the engine from steeling all your warm air in the cab?

I'm much more interested in the mechanical self leveling capability of the new FEL they mentioned. I can't find any other info on it anywhere though.

You are mad scientist of epic proportions! Great job! (I think it's safe to say the rear end will remain firmly planted no mater what yu try to lift with the FEL!)

Now THAT might be a good idea! I too am a synthetic fluids disciple. I just haven't had the occasion to think about it for hydraulic fluids.

I started a post about a "Top & Tilt" kit for a BX2370-1 here: http://www.orangetractortalks.com/forums/showthread.php?t=28375 Sure enough... That slot is for the two valve handles that can them be used for controlling the top and tilt cylinders. Top & Tilt are ALMOST essential (IMHO) if...

Thanks for all the info. I think it will require some sort of custom mount for the valves attached to the lower ROPS. Other than that I think it's doable.

Thanks for the clarification on where the actual "reservoir" is. Is there a good flat spot (and what size) on the bottom of this rear end or is it cast with stiffening webs everywhere?

So my cousin who lives in Wisconsin just bought a BX2370-1. The manual says you don't need the block heater unless the temp is below 5F (-15C). Heck. The dealer there didn't even really seem anxious to install one! I advised my cousin to get it anyway. So reading the manual further it...

My cousin just bought a BX2370-1. She is going to want to do some trail creation and I've told her a box scraper with a top & tilt set-up is the bees knees. Of course any "kits" seem to be for the larger models. Does anyone know of a kit specifically for the BX? And what is the spool valve...