JonM's latest activity
-
JJonM replied to the thread Lynch pin instead of snap rings? - BX 3 Point Hitch.you can use a lynch pin to secure a clevis pin. if your using lynch pins just be sure it will fully close and stay closed in all...
-
JJonM replied to the thread L5240 HST filter.i wouldnt use anything but kubota filters for hst and hydraulic. pressure is too high to fk around with cheap filters. oil filter is...
-
JPush the ⬆︎ to go forwards Push the ⬇︎ to go backwards Easy peasy :ROFLMAO: :ROFLMAO: :ROFLMAO:
-
JJonM replied to the thread How Hard to De-Green an MX5200?.what causes emmissions issues with dpf is ignoring the regen. my 6060 when the regen light comes on just throttle up until the up...
-
JJonM replied to the thread Advice on hydraulic quick couplers.if its always going to be attached anything is fine. great for pioneer as they are cheaper if your going to be using it with the...
-
JOne thing that takes a the fussing out is put a paint mark on the spreader for setting per each implement…then you can readjust back to...
-
JJonM replied to the thread What did you do to or on your Kubota today?.does running over your phone with the tractor count???? it must have fallen out of my hoodie pocket this morning. now its got a...
-
JJonM replied to the thread Battery questions???.i use noco smart chargers. you can get a usable charge in a few hours. place it on charge when your not using the tractor until its done
-
JJonM replied to the thread Oil level inconsistant.hydrolix oil expanss a lot with heat
-
JJonM replied to the thread Battery questions???.#1 makes no difference. #2 if your going to charge the battery with a charger disconnect it completely before using a charger.
-
JJonM replied to the thread What did you do to or on your Kubota today?.the 2024 version doesnt matter if the brake is on or off it stalls by default with pto on if you get out. i tried all sorta of...
-
JJonM replied to the thread What did you do to or on your Kubota today?.doesnt work on the air ride seat. i wish it was that easy. mine is a 2024 cab l6060 with airride seat
-
JJonM replied to the thread What did you do to or on your Kubota today?.got around to bypassing the seat safety so i can run my pto wood chipper. just made a 2 pin deustch connector and depinned the safety...
-
-
JJonM replied to the thread Ran well and then...anytime your going to charge a battery with a charger you really should disconnect it from the tractor/vehicle. modern computers and...
-
JJonM replied to the thread Don't buy a bigger tractor than you need..i bought the biggest tractor i could that would still fit through the horse arena doors. i have not yet said the 6060 was too big for...
