JonM's latest activity
-
JJonM replied to the thread What did you do to or on your Kubota today?.make sure the hydraulic fluid is at operating temp before which is usually higher than ambient. when it cools it decreases volume...
-
JJonM replied to the thread What did you do to or on your Kubota today?.greased the front end wrong and it snapped a bolt. cost me two new bolts from kubota. idiot tax was only a half day down time and 16$.
-
-
JJonM replied to the thread Are all pallet forks created equal?.dont get forks that are rated substantially higher than your fel can lift. same or slightly above. going really big just reduces how...
-
JJonM replied to the thread Published weight.i haul my l6060 with fel bh92 backhoe and filled i have a 14k 20' trailer with beaver tail and that setup barely fits. so length is...
-
JJonM replied to the thread RPM for bucket.float takes practice thats for sure. onve you get the hang of it, its aweaome for scraping large areas.
-
JJonM reacted to BBFarmer's post in the thread What did you do to or on your Kubota today? with
Like.
Looking at your grill guard reminds me how mangled mine actually is. Oh balls! -
JJonM replied to the thread What did you do to or on your Kubota today?.was cleaning out the dry lot and wondering where all the horse poop was... found it in the shelter they never seem to hang out in...
-
-
JJonM replied to the thread Turning the pumps up!.wouldnt do it. the hydraulics are set so you wont hurt the tractor or loader. upping that power gives it enough power to do damage...
-
JJonM replied to the thread Oil flush?.welcome to diesel engines. they all do it even my truck. its normal. if your concerned send an oil sample to blackstone labratories...
-
JJonM replied to the thread Gummy Fuel Fix ( for stupidity ).i would not do that. your going to have to clean each section of line clean the tank change the fuel filter and hope it didnt gum up...
-
JJonM replied to the thread What did you do to or on your Kubota today?.prolly has something to do with the subframe
-
JJonM replied to the thread What did you do to or on your Kubota today?.putting in scratching posts for the horses in their dry lots going to cover them in scratchy doormats and bristle brushes
-
-
JJonM replied to the thread MX 6000 or 5400 Backhoe Install.installing the needed hydraulics is a complex task. i would say not a diy project. kubota installation directions leave out a lot of...
-
JJonM replied to the thread What would you do?.ive thought about a 3 point mower of some sort but i already have a really good commercial zero turn. and it seems like a huge step...
-
JJonM replied to the thread What did you do to or on your Kubota today?.all i did today with the tractor was empty the horse poop out of the bucket from last nite and bring the horse water troughs for a clean...
