Recent content by Joekelsch

There's another decal in the pic. I notice it standing there, but how I angled the phone it came up in the pic.

There's a knob under the seat. Does that adjust the 3 point lift capacity?

Thank you!

Everything works now. The only time anything comes out of the OUT is when I'm running the levers.

Yes. And it was high pressure.

I pulled the loose hose and attached the remote. That definitely does not work. The only way the attachment worked was when the B port from the tractor was attached to the top of the control valve and the remote out the bottom.

I wasn't sure what you meant. I disconnected the remote line and attached the line from the B port from the tractor. Where I had that line before I attached a line I had laying around into a bucket. The flow was excellent.

Both of these ports have large adapters unlike every other adapter.

The hose I'm talking about is on the left going straight down. The OUT on the attachment is on the right with the new hose and the pipe fittings.

There is a remote plumbed out of the bottom of the valve. It's the smaller diameter hose. The other remote is plumbed into the branch of pipe fittings that come out of the OUT and go into the A port on the tractor. Could that be it? Is it worth swapping the two?

I looped A and B and the 3 point and power steering work fine. It started great without struggling. Could there be something gummed up or stuck in the attachments control valve? All the levers go back and forth freely and they do what there meant to do. It did sit in a shed for 15 or 20 years...

The directional valve is in all the way (clockwise) finger tight. The 3 point goes up eventually. The power steering is pretty much nonexistent. The tractor is difficult to start. I thought maybe the battery was dying and it was. I charged it overnight and acts the same way. I also found out...

After turning the valve as far as the instructions say, I got a strong flow with no noise out of the OUT port on the attachment. I put the OUT hose back on the A port. I started the tractor again and levered through the attachment. Everything worked but there was a little noise from the pump...

Do you mean port A on the tractor?

I swapped the lines on the tractor and followed the instructions on the label and it mostly works. I couldn't get the directional valve fully to where the instructions say. With the tractor running you can hear the pump making noise so I backed it off. If I keep the tractor above 2000 rpm it...