Yes, I will But from what I am reading they say it comes back quick because of the pressure that builds up and that is what is most likely causing the leak so I would like to address both.
Just wondering what are your guys thoughts on venting the front axle, I have SUTD fluid and a slight leak on the left side, When I take dip stick out I do get a burst of pressure. I am unsure if I should vent it or switch to Gear oil before changing seals.
I use the Boyd welding clean out, I had it installed and tank cleaned in under an HR. The sender is rusty on mine and plugged the outlet. Next time I am in there I will clean the sender better and it has stopped working again.
I would lean towards a seat switch or the outlet of fuel tank getting clogged, If it does it again pull fuel line off and see how the fuel is flowing before the filter.
Yes Both of those have popped up, I believe the official kubota sight lists the 32430, Messnick lists both as does colmans depending on the search engine I used. Guess either will work, Guessing maybe there is a size difference?
Hi, I was on official kubota sites looking at the part numbers and they were all different even their superseded numbers. Just looking to grab a filter for the oil change the way the filter is on machine I can't read i.
Thanks
Does anyone have pictures of the Different style gauge clusters used over the years in the BX25 Series? I believe my tractor is and 2014 and looks like the one in the picture I believe or it was used for more than a few years.
I don't have a picture handy but lift the seat and I centered it on the flt part of the tank right under seat. I also did Fuel filter relocation with Bigger filter and the bowl.