Recent content by jkavanagh58

Funny you mention that... I took out the grinder when one of my implements bottom pins were not fully seated. It was just one side. Then I walked through it... the lower arm adjustment... backed that to standard setting and now both pins sit nicely... ugggh

Maybe not today but today is when I had time to document it. Getting ready to harvest so picked up a new undercutter. Just more of the CAT 1 standard and how that really should be revised. New attachment and a new top hook configurationn.I love that that QH16 has a wide range of settings from...

I threw the Quick Hitch (QH16) on and while not easy connecting to a non-Land Pride implement, that previously took considerable effort to attach, took about 30 minutes. Now I would point out that the implement posts need to be a little longer for the lower arms attachment but hooked up and...

The Quick Hitch has been a nice add to my 3302. It works great with my Land Pride implements but I have had issues with another implement.

I did go with a dead blow hammer (it’s orange and won’t rust) and did some serious work with it to get the tab into the arm.

I like how you think, just not sure the budget allows for that 😁

Outstanding. Definitely lesson learned, one of many no doubt. Attaching and Detaching the LP tiller seemed simple enough but that was all the experience I had, until now. Yeah, no pallet forks. When I brought the implement back it was raining and lets just say it was just dropped. My first...

Outstanding and thank you @RCW My Kubota guy brought a quick hitch over for me to try. I was attaching a Nolts Raised Bed Layer to my L3302. This was frustrating as my plan had been to run the hopper over the field for fertilizer and pest control, then start running the beds. After all of the...

Well technically not today, but first chance to post. Monday my day was taken up trying to attach an implement... ugggh. Being a Newb I expected some things wouldn't be as advertised but yikes. Granted the equipment was on a pallet on less than flat land and not even square to the pallet. Quite...

I did look at those and was considering... then I hit a groove with the BucketDriver and started making good progress.

I agree 100%, still a newb so I am still perfecting... I place it offset mainly to make it easier to get off tractor, line the tool up with post and then operate the controls while off tractor... centering it up would be a few more steps :)

Yeah, when it works it is great. BucketDriver 5

I did look at that but I opted for the BucketDriver because with the same tool, in a few days I will be driving these same posts with the same mechanism.

Pulling TPosts. Learning how to use the BucketDriver to pull TPosts from the ground. I am a tractor newbie and that adds to the fun. Also. first stab at tilling pieces of our plot. So much to learn. :)