Jim L.'s latest activity
-
JJim L. replied to the thread Fire - warranty coverage?.I'm not saying do this - just another possibility. Some of the protective covering looks melted. If the conductors underneath are OK...
-
JJim L. replied to the thread L3800 HST Oil Inlet Cap Trying to order from dealer and now online.If you're talking about the hydraulic oil filler cap, a Kubota "Plug" 38240-21410, Messicks has the Kubota part. The O-ring is...
-
JJim L. replied to the thread Diesel engine sucked up water! Now what?.When going into the creek, the machine needs to be shut down before it gets water into the cylinders. Water being incompressible, the...
-
JJim L. replied to the thread M7040 - AC works but blows hot after a while.The real diagnostic test to to measure and record high and low pressures; and, temperatures. However, if it cools for half an hour and...
-
JJim L. replied to the thread Kubota B7100 wiring problems.is there a way to test the new electronic module? 1. Assuming the alternator is functioning properly. 2. Overvoltage may indicate a bad...
-
JJim L. replied to the thread Kubota B7100 wiring problems.The new charge light flashes more than a strobe system, but the alternator is now pushing 16.8 v into the battery. 16.8 volts will...
-
JJim L. replied to the thread Kubota B7100 wiring problems.I would expect to begin the trace from the regulator connector. Its pins are shown on the device with respective designators. IG, N, F...
-
JJim L. replied to the thread Kubota B7100 wiring problems.When the tractor is running I am measuring 10.5v across the battery terminals. Not charging. With the posted pictures we get a better...
-
JJim L. replied to the thread Kubota B7100 wiring problems.Bit of a recap on what is needed: Alternator brand and model number. Regulator brand and model number. Original was a 2-wire AC dynamo...
-
JJim L. replied to the thread Tractor PTO Sensor Plug.Likely a Yazaki or Sumitomo connector. For clarification, did the wire break or pull out of the contact? If the contact and connector...
-
JJim L. replied to the thread L3200 Valve cover removal.There is a trick to getting the fuel tank off. You already have the hood (bonnet) off. Now remove or move aside the instrument panel...
-
JJim L. replied to the thread Is a glow plug a glow plug...a glow plug?.NGK and Bosch are well-known with good history. As pointed out, go to a good supply chain so that you minimize the chance of knock-offs...