Recent content by io540

I did not post what model Kubota. It is a 2050DL. This is what happens when you age.

I am getting mixed messages. The bucket slowly drops when the engine is off. Is this more likely due to a cylinder problem. I see no evidence of fluid leaking. Or would it be the control valve? Help is greatly appreciated. To many "experts" here. Thank you.

Also John Deere sells the relay. I paid around $20.00 for it. Someone posted how to make one.

I have a 2050 and had a similar problem. I did a great deal of searching and found this on ebay and it is similar to the one in the starter. I have not tried it as of yet, but it is exact. Also there is a thread conceding a relay that attaches to the starter, and it rejuvenated the one on the...

I replaced one seal and as advertised when the snap ring was removed, the unit came down. Thanks to those posting, I had it braced. When I attempted the other side, the case wouldn't drop after the snap ring was loosened. I did use a BFH, but maybe not enough. Does anyone have suggestions how...

Thank you for the response. I will try the oil. I have purchased the "new and improved" seals from Messicks. They could not find the originals. The new ones are slightly over $40 bucks.

I am going to replace the front axle seal on a L2050DT. To do so, do I have to remove the tie rod?

I have a L 2050 4 wheel drive tractor. The safety switch is not getting power at the starter. I would like to find the safety switch so I can replace it. Could some one give me a hint where to look? I assume it is under the dash. I do have a wiring diagram and the wire to the switch from the...

After downloading the parts manual, it appears there two plates and a brake disc. I am fairly mechanically inclined. I am wondering how difficult this would be?

I have a L2050 four wheel drive. When going down a slight incline with a load, I get chatter from the left side when I apply the brakes. Is there a solution to this problem?