Recent content by Havack

Thanks for posting this. I found that on Messick's after I posted. Would still be helpful if I had an actual picture. I now know where they go but In that diagram the two springs I need to know about, they look the same but are very different, so I don't know which spring goes in which spot.

I need some help. I have been working on an older ZG327 and I am not sure I have the carb/governor springs back on correctly. I took it apart to fix an oil leak and while it does start, it now starts hard and act funny link the carb is not right. There are three springs that it has . One is...

Should have said switches and it was the arm switches I bypassed.

So I think my problem is solved. I replace the brake switch and I think I was sold a switch for the arm instead of the brake as it should be closed when the brake is applied but it is open when the brake is applied.

I have a ZG327 project. I think it is a 2009 year with 2200 hours. it runs well sitting. You can turn on the PTO and it still runs well. The problem begins when you want to move. If you move the arms (either one) it will move. After about 3-5 seconds it will die and if you put the arms...