Recent content by Goldsmith1

Everything went well and i ran it for 30 minutes working on our road and all looks good.

Thank you, I went down the mountain Friday and got everything I needed other than they didn't have any of the clips. I went ahead and pulled the cooler so I could clean the hydraulic off of the radiator and motor easier and replaced both Orings. I am going to go drain what remains of the oil...

I am also not able to find the schematic for this area of the tractor anywhere. I haven't even been able to find it in the service manual.

Thank you very much! Definitely is coming from that connection but not sure if o-ring or pinhole. It's pretty much out of oil now and afraid to run. It's foaming when it comes out and none is showing on dipstick. I had it running for about 5 minutes before I knew I had a problem. Nearest...

030, is that an oring that might have gone bad? Do you just pull off the flat metal v 040 to take apart?

I was working on our road yesterday and the oil cooler dumped pretty much all of the oil out. It seems to be leaking right where that metal V is circled in the pictures. Once again I'm messing with something I have no experience with. In the picture it appears this is where the cooler is...

When I've ordered from them before I never saw any shipping less than $20 plus dollars. Maybe I should call and ask the next time.

Thanks for the reply. The reason not to buy from a dealer is it's a 2 1/2 hour round trip. The reason I wanted to buy locally is I had hoped to get them sooner, plus I'm in an area in the NC mountains that hit pretty hard by the hurricane. Any and all money that can stay here needs to...

Looks like the 2649 is the correct one. They cost about what the dealer charges for them which is three times more than the ones they got for me the last time. They will be in later today or in the morning. I will let you know if they're in fact a match. Thanks for your help.

No, I can't find any markings at all. Tractor is a 2013 and I'm guessing these are the originals from when it was built. I have to go return these today and will take your information above with me. Thanks!

Wanted to get locally if I could. I may just make the 2.5 hour trip to the dealer to get them . I was trying to save money and time and it has ended up costing me a week.

Pulled one and took it to a Napa store. The guy behind the counter pulled his calipers out to measure it. It took a week to get them partly due to the holiday. When they came in the were the correct length but to large in diameter. Any hell would be appreciated.

Yea, I had hoped I could just keep adding oil and stopped at the dealer on the way back up the mountain and bought a gallon jug. It let me know real quick that wasn't going to work. Definitely bad timing on this breakdown as usual.

I had hoped I could do that but unfortunately it is past a slow leak now.

Thank you. No I haven't. I will but I think I'm leaking from a different area. Tractor has been covered in mud since the storm hit us until today. Will be getting into it in the morning.