gleneben's latest activity
-
Ggleneben replied to the thread bucket tilt.i know ! i was a mechanic in the army for 20 years and never experienced anything like this. if you have pressure , you always have...
-
Ggleneben replied to the thread bucket tilt.yes they both are on the right side but when the fluid came out of the valve i blew air through the hoses and the lines in both...
-
Ggleneben replied to the thread bucket tilt.with no lines on the right side of the control block the best i could get was about a 3" high stream. when i took one of the lines off...
-
GDobit BEFORE you tear the valve apart!!
-
Ggleneben replied to the thread bucket tilt.i will try that first
-
Ggleneben replied to the thread bucket tilt.im going to try that after i check the control valve for debris
-
Ggleneben replied to the thread bucket tilt.i will check for that , i used the liquid teflon but when i took teh lines off they were installed with tape.
-
Ggleneben replied to the thread bucket tilt.it was my fathers and it did work, i rebuilt the tilt cylinder on the left side but i did not start having issues till i changed the hoses.
-
Ggleneben replied to the thread bucket tilt.i took both lines on the right control off and got a spit --- drip ,drip ,drip basically nothing
-
Ggleneben replied to the thread bucket tilt.i will do that tomorrow and let you know what happens
-
Ggleneben replied to the thread bucket tilt.that is very possible that a line is hooked up wrong i replaced all the hydraulic lines , even though i tagged them all i might have got...
-
-
Ggleneben replied to the thread bucket tilt.yes i ran it in both directions towards the back fluid came out at a very slow and towards the front of the tractor no fluid came out it...
-
Ggleneben replied to the thread bucket tilt.the metal line on the cross bar i took off the line going to the rod end of the right tilt cylinder.
-
Ggleneben replied to the thread bucket tilt.model is 1200 on the loader
-
Gi have a L245DT with a front loader. the bucket will go up and down but wont tilt front and back. i took the splitter line that feeds...
