Recent content by GCP

I have a BT602 backhoe on my tractor with a torn dust boot on one of the control sticks. I thought it would be a simple matter to unscrew the knob on the end so that I could remove the old one and slide on a new one. This does not seem to be the case as the knob won't budge. Does anyone know...

I'm new too, and have a BX25D,so it may be different, but the PTO isn't used when I'm using the backhoe, so it should be off. The speed of the backhoe is controlled by the throttle and operates only on the hydraulics. The dealer said at least 2000 rpm, and the manual says no faster than you can...

I have a dysfunctional relationship with my grease gun. I hate it and it hates me. Searched all over for moly ep grease 'cause that's what the manuel says to use. All I found was lithium. Finally wound up trekking to the dealer where I bought Kubota brand. It's lithium too, plus some secret...

A gallon an hour seems close enough.

Doing less is best. I'll resist the urge to top off and see what happens. Not sure how to tell when Ive burned a few gallons. I've read that letting it run out of fuel is a PITA and requires bleeding the fuel systm. This used to be a common probem on motorcycles, but most of them now use...

Lots of good ideas here. Think I'll start with the dealer, then maybe go looking for the sensor connection. I have a voltage meter. Are there any readings I should check? Thanks!

I have a new Bx25D that always shows full on the fuel guage. The tractor blew the dashboard fuse the first time I asked it to do some serious work. Not sure if the two issues are related. Also, I never burn more than a couple of gallons before topping off. Would need to rent a trailer to...

With 9 hours on my new BX25D, your articles and videos have been a tremendous help to me. I've discovered that the better my technique gets, the better the tractor gets. Its an awesome machine. Thanks to you all.