FTG-05's latest activity
-
FTG-05 replied to the thread Fill-rite 12vdc pump experts needed: WTH?.Yep. The wires on my Fill-rite 120 vac pump were well tucked in the junction box when I received it. Got a reply from Fill-rite... -
FTG-05 reacted to hedgerow's post in the thread Fill-rite 12vdc pump experts needed: WTH? with
Like.
I have wired a ton of those pumps over the years and those wires shouldn't be sticking out of that connector. They get spliced to the... -
Will it shift with the engine not running?
-
Also dropped the oil. No metal chunks or anything indicating internal failure.
-
So the brake switch it working properly just changed the neutral safety cable isn't seized or stretched. Still wont shift out of...
-
Thats funny but closer to the truth than it seems at first glance. For the novices amomg us get a hand full of 6, 8, and 10 mm bolts...
-
Tighten until it starts to break, then back off a half a turn
-
I cannot follow you here. You have a table with the torque to be applied for each bolt diameter and strength. You simply set your...
-
I'm just trying to find some method better than the old method of tightening bolts up to one quarter turn before breaking. Thanks for...
-
That of course is the tried and proven German engineered GootenTite specification. Dan
-
I give random bolts 2 solid uggas and half of a dugga with my 3/8 rattle gun.
-
Your attached photo indicates that "Figure 7 on top of the bolt indicates that the bolt is of special material," with the accordingly...
-
Hello, very good question, I would like to know myself if 7 for example corresponds to 8.8 10.9 or not. Attached is a table from the...
-
There are a lot of general purpose bolts on every Kubota tractor, but I cannot find much information on them. There are no grade...
-
FTG-05 replied to the thread Fill-rite 12vdc pump experts needed: WTH?.After writing this out, I think you're exactly right. Note that the first instruction is to remove the junction box to get to the...