Recent content by Friscokid320

Ask for Frank Damato or an inside sales rep. Tell them what you have and they will set you up. Bill

stucchiusa.com

Just had an OH CRAP moment. Just found the specs on the Eaton hydraulic motor and just calculated the flow rate. I have the standard flow motor. 18-22gpm. YGTBSM! I think my motor's shot. Bill T.

I agree with not being able to see the actual flow rate and pressure. Such a goofy system. I'll try that tomorrow and see. I have an aux 1 setting on my that de-rates the high flow.

It was suppose to be a high flow as the hoses were 3/4". The model number on the motor does not correspond to the number listed on Land Pride Parts manual. The number on my motor is Eaton 104-4840-006. Its a Char Lynn Eaton motor. The Land Pride parts manual number is a proprietary number...

Yes on the case drain and the gauge is installed but doesn't work. Talked to Land Pride today and they are stumped.

Have you cleaned your carburetor bowl, needle valves and carburetor body?

I have a Kubota SC4072 mower that I run on my 2017 Kubota SVL95-2sc. I have been experiencing a possible back-pressure problem. The mower is running fine and the machine RPM's are running at 2480 and all of a sudden I get a drop in mower rpm's and engine rpm's. The engine rpm's drop around...

I have been watching if anybody on here has replaced their high flow flat face couplers with the Stucchi products on their SVL's. So far the search hasn't resulted in many inputs on the forum. So, I purchased the kit from Stucchi and just put them on my 2017 SVL95-2SC (8/27/24). The kit is a...

Whitetiger, Thank you for the input. I did as you recommended. Approximately 4 hours for the tank clean out. Since I'm a little older than most (and a lot bigger), it took 3 days to get it done between rains. I would agree, this was not rocket science. The tear down was as you stated. Got...

Whitetiger, Also, I keep my machine very clean in the internal engine area as I run a FAE mulcher. Fire scares the you know what out of me. Friscokid320

Whitetiger, Thanks for the input. Since the machine is stuck in the field, I'll have to accept that situation and get busy. Good to know about the TSB. I'll get with the dealer and see what they come up with. Good info! Thanks again. Friscokid320

Any SVL95-2S owners done a fuel tank clean out yourself? I have been throwing a E:9302 code with the RED Triangle Exclamation Sign and the machine goes into limp mode. I looked at some of the threads here and performed the maintenance items recommended. Those were new fuel filter, removed and...