Recent content by flh77hd1

Hi guys, got started again since holidays are over. Drained out excess oil. Runs better. Didn't just change one seal on pump i just tore it apart and changed all of them. They didn't look like they were bad but since tore apart i changed them anyway. Also took the directional valve off on the...

Adam, not sure if you done this yet but i did mine. move the fuel filter out of the way, take the supply hose and the return hose off. Three bolts are very easy to take off it's a 12mm wrench. The top bolt isn't a bolt it's a stud with a 12mm nut on it. I took it off by double nutting the stud...

Thanks Bandaidmd & Wolfman. I'm still going to change seals on pump and motor oil after. Another exercise but if this works it's worth it.

Wolfman, i ordered all the seals. What made me notice the oil yesterday was the idling. It was reveing up and down. i backed back into the garage today so i can work on it and it idle fine and wasn't blowing oil out the breather tube but once it warmed up it did start spitting again and the...

Gottcha, checked with someone here local and he said the same #13. I think i'm going to pull the pump and check out all the seals and replace. But i am going to drain the oil and refill as you said. Thanks Man

Please see attachment. When you say seal is it the gasket, #22 on the parts diagram ?. So you know that on the oil stick it's running all the way up it. I had just changed the motor oil before the hydraulic issue. It doesn't smell or feel like hydraulic oil on the dip stick. Also the coolant...

Hi, having problems with my Hydraulic pump on B8200 as well but Wolfman has been hanging tuff with me so far so here is my way of taking pump off. It has three nuts wich is simple to take off but the back one has a nutted stud. I double nutted the stud and backed it out. And installed the pump...

ok heres what i got. Somethings working right because now i have power steering and 3 pt. Tried hooking up loader but have to wait until i get an extra set of hands. I know i have some pressure coming through the hoses that connects to the loaders spool controls but since it supposed to be high...

Today spent 10 hrs. working on tractor. i removed every section of the hydraulic hoses and blew them out with air. I replaced any O-rings that looked worn. I unclogged the only vent there is which looks like a hook. I purchased and installed new screen filter as you and bandaidmd stated (spent...

Hey wolf man, cleaned the vent. Tomorrow night i'm taking off the suction line and i'm going to blow air to make sure it's not obstructed. Then i'm taking the returns off and blowing them through. I have had enough piece mealing this and guessing at everything. I'm going to make sure lines are...

hi again. I read to check the vent located above the 3pt and at the 3pt pump. I unscrewed it and a lot of air came out. I tried to updoad pic of the pump but it said i exceeded the limit. So i don't know what else to do. I took the loader off so i could work on getting pump off. Even still when...

Update. Got home to see if the hydraulic flows. Well after about 5 minutes i turn the spool valve towards front and push in the quick connect to see if guild would shoot out and not it just drips so i pushed lever for 3pt to lift and it did not lift. i turned the spool valve to face the back and...

Hey Wolfman, It only has one pump. I spoke to someone today who said the same thing. You said spool valve, now is that the valve that you turn in one direction or the other for the hydraulic to flow to the loader or turn to the back for those hydraulic to work. Yes this is the only hydraulic...

Hi, hope this helps.

Had the same problem. i double nutted the stud and backed the stud out and pump slid right out. Put the stud and pump back on the same way. Hope this helps but agree. What a dumb design.