Recent content by Finnberg

I have mostly level ground and road sides are what I'm planning to mow. I can add my snow plow to the front lifter to get more weight to the front and fill the rear tires. I can drive with low 1st or 2nd to maintain control if necessary. I just don't want to break the tractor with too heavy...

I heard that L245 rear axle casing is weak and might brake near the bearings if there is too heavy load in the back. Is this true? If so what kind of mowing machine for road sides is suitable for L245dt or do i need to buy newer tractor? 😄

Hi! Am I able to run this kind of verge mower with L245DT or is it too heavy? I'm considering the 135cm wide version. The 115cm is only 16kg lighter than 135cm wide version. I have rear tires at the widest setting...

Happy to hear you fixed it. Forums like this are golden! 😊

Thanks alot! :)

Hi! Can I jack my tractor up from under the tow hook (or what is it called?) and then put jack stands under the axle? I'm going to widen the track of the rear tires. Thanks!

Update: I just finished fixing this. There was an o-ring on each delivery valve holder. The o-ring had a slight blue paint strip on top so I'm pretty sure it came from factory like this. The o-rings were all hardened and cracked so i replaced them with 14x2.5mm o-rings. I also replaced the...

Thanks! I'm bit nervous because I haven't done this before but I hope I can do it. I have access to a decent torque wrench, any idea what is the torque spec for those holders?

I asked from https://injectionpumps.co.uk/ (because they have same model rebuilt injection pump in stock) if I need copper washers only or copper washers with o-rings too. They answered: "Hello You will need both 09013-90410 and 09013-70130...

It says "DH1101-A-26396"

This gets interesting.. My injection pump looks like this. Delivery valve holders look different on mine than in all the posts that I've seen. Identifion plate on my pump says "094500-0612, NP-PFR3M55/1ND061" Maybe the pump has been replaced at some point? The tractor has around 4510 hours on it.

Mine doesn't leak when motor is running. It leaks only if I leave the tractor parked and fuel tank valve open. On the video he is changing the o-rings to stop the leak. Can fuel leak inside the motor if o-rings are sealing but copper washer isn't? Why in earth there is versions with o-rings...

I found this: https://www.orangetractortalks.com/forums/threads/weeping-seeping-injection-pump-fitting-dilemna.17064/post-134335

Hi, My L245DT fuel pump has a small leak under middle delivery valve holder. I'm assuming it is the copper washer that needs replacing in there. In parts manual there is no o-ring under the holder but i've read that i can add o-ring there. Is that ok and does that take care of the leak? Or...

I have a front lifter attached under the tractor and front pto shaft. I have to work outside under the tractor so i was hoping i could change the seal without dropping the front axle. Is there any chance without dropping the axle?