Recent content by fbson395

You Might try ebay for the pump you are looking for. I found a new one on ebay for much less than dealer cost. Good Luck

Have a used power steering unit from a B7800. some damage to the top shaft unit was not leaking . Was replaced because insurance paid for repairs. Will sell for 100 + shipping in USA.

If you still need those parts try Desert Auto Kings.com

First off, Good Luck with your new tractor. I bought a L245DT with many problems. One of which was the steering. You can adjust the steering box and remove most or all if the play. On the box it will have a nut with a slotted bolt,loosen the nut and with a screwdriver turn the bolt. Then be sure...

Here are the Installation instructions for ROPS that were purchased from Kubota. Hope this is a help or at least the information that someone can use.

Just got a set of ROPS for a L245dt from Kubota.I can send you a copy of the installation info. Let me know if you still need them.

swamprat009, I also have a L245DT, and will put power steering on it soon as the parts come in. go to this site http://www.tractorpowersteering.com/ Rick has a kit that will install with a little welding and fabrication.I have a FEL on my tractor , if you need any information from me let me know.

Kubotaman, Glad to hear you got power steering installed. I plan on installing it on my L245DT. For anyone who wants to install, try this site. http://www.tractorpowersteering.com/ Ask for rick, he has a kit and it's price is about $500+ . He has been out of stock on some of the parts and I'm...

Brunswick000, Just repaired and refill the front axles on my L245DT. The end drive units have a drain on the bottom and a fill plug on the top.Each end unit took 1Qt. then The axles have a fill plug as you stated and another Qt in each of them. You May want to run your tractor for 20 min. and...

On a different tractor site I seen where a guy run his return in the oil fill hole. Put a pipe tee in it and extended his dip stick. Might be a option. Best of luck!

I don't know if this will help? My L245DT would get stuck in reverse. I removed the top of the trans with the shifter on it. The forks have to be in align to shift easily. The top of the forks were worn and stopped the correct alignment. I took it apart and silver soldered the worn areas, then...

Just got a l245DT and not much time on it yet. Got it cheap as it had things needing repair. You might check the front end for wear.mine is down to replace the bearings. The drag arm was worn where it has a grease fitting on top.Check for worn steering parts.Also my trans would not shift out of...