Recent content by estapleton302

Just following up in case others have similar problem. Tractor was taken to dealer and diagnosed / fixed in about an hour. Somehow the shuttle cable running to the shuttle valve, the pin came out. Replace shuttle cable pin and back in service. $10 in parts and $180 in labor/transport. Live...

pulled battery and had it tested at NAPA. Despite what my multimeter said, the battery tested fine at parts store. 12.74V / nearly 1100 CCA. I’m running out of ideas, dealer might need to diagnos. I’m convinced its some sort of safety switch. But I just don’t have the knowledge to look for...

Checked the bottom shifter cable and seems to be moving back and forth as it should. Good call though. I didn’t think to check that before.

That is just the steering wheel linkage. It’s the bottom knuckle. No issue there, steering works without any issue. I can see what you mean though.

Sorry Dave it’s a M7060HD 4WD ROPS 8-speed. Doing alittle more diagnostics on my own and the battery is coming up at 11.70 volts resting. That’s low/bad. Would that affect the shuttle shift or starter?

Was on hill side and started to roll back and popped clutch a little and then it would not show Neutral or go in reverse. Rolled back to level ground and tried shifting but would only go forward, not reverse and would not show “N” on shifter. Turned off and instrument panel works but still won’t...

I am having a similar issue with M7060. My switch will engage no problem, but it will not disengage with the switch. It must be turned off and let it sit for 5-10 minutes, then will shut off. From what research I have done, the solenoid will likely be to issue.

Has anyone had to have their PTO solenoid replaced? If so, what was the approximate cost of repair at the dealer? Also, I live in Central Virginia (Culpeper), anyone have a recommendation or good experience with repairs with a local dealer in this area? Thanks.

HEllo Dennis. I have almost the identical issue happening with my M7060. It engages with switch no problem, but most times it will stay engaged when I disengage switch. I console says it is off but still in on and under power. Did you ever find out what the issue was? I sure would like to...

HEllo Dennis. I have almost the identical issue happening with my M7060. It engages with switch no problem, but most times it will stay engaged when I disengage switch. I console says it is off but still in on and under power. Did you ever find out what the issue was? I sure would like to...