Recent content by Erland

My Charge System light was staying on and the Dynamo tested no output with my volt meter set for AC. Is it possible to repair or is it just a replace? If replace is necessary, what is the best source other than the dealer?

UPDATE: One of the hose sleeves was covering a QC that I had not discovered. It was completely disconnected. :rolleyes: EVERYTHING WORKS FINE NOW ... except the charge light doesn't go off. That shouldn't be a big deal either. :)

Well ... cleaned out quick-connects and did not help. Checked the repair manual and it suggested I check the Relief Valve pressure. That pressure is nonexistent (zero). As I read the manual (pg 5-S1), I need to tear apart the tractor to either repair or replace the Relief Valve! :mad...

The color codes on the hoses match to the controller (and I couldn't physically exchange the two I blew out). Therefore, it must be clogged connectors. How do you get them unclogged? Do they have to be replaced? Sure appreciate your help on this!

I did blow out the FEL lines. I could have mixed up the lines going to the controller but would that affect the 3-pt? What is the BH loop?

Was tilling and digging out brush the other day when my tiller would not stay up. Found out I had not changed the fluid for 500 hours, so I changed it only to find out it was milky w/water. Replaced it twice, with a diesel bath/shake in between and new filter. Problem persists and the dealer...

For a long while I have had to center the 3-pt manually after selecting to raise the implement. (Also, when raising, it often did not raise all the way.) The other day it stopped holding up and will not lift at all, also affecting the fel so that I could only move it up or down by also...

How do I start a new post?