Recent content by EPIC

Stick or MiG will work…. Assuming you are not welding in a windy area. High winds can blow the shielding gas away. Concur with bevel and pre-heat. But don’t forget that weld heat can and will pull material out of square, so make sure you have it braced well before you start! I would use MiG...

They make different size augers that require different amounts of hydraulic flow, and can run different size bits. If you want to try it, check the specs and get the closest you can to your flow and pressure. Just as an fyi if it turns too slow it won’t remove dirt from auger, you might need...

Cars typically have a very slight toe in to help them track straight. your tractor probably doesn’t. Assuming both front and both rear tires have matching air pressure, it may just be as simple as the crown in the road. Assuming it always pulls one way on the road, but fine in an open field...

I am far from an expert on aerators, but I had extremely compacted soils when I purchased my property in 2011, and all the research I did indicated aerators that removed a plug were best for soil health. Key factors from my research and limited experience are unit weight, type, cost and build...

Found some answers while adding the camera kit, which by the way was easy to do. The instructions to be the correct installer/service-mode entry procedure for the KX040-5’s 7-inch monitor, including the keyless-start version. The KX040-5 does use the new jog-dial display and keyless starter...

No idea about the land pride, but I have a 6’ model that does that I got from everything attachments about 10 years ago, use it 2-3 times a year still works perfectly. https://www.everythingattachments.com/Independent-Wheel-Lawn-Aerator-p/ea-xd-la.htm

Is this what you are looking for? https://www.discounthydraulichose.com/2HTF2-HT2F2.html

Also check numerous dealers, even if they are all part of the same company, you can sometimes save a substantial amount of $ and still get free delivery. in addition check online to see if you can add third function kits that you can add yourself this saves shop labor, assuming you are...

I am sorry I can’t help, but just for fun I asked chat… this is it’s answer If you’re referring to the Kubota B2778 60-inch front rotary sweeper, adapting it to a Kubota B1700 is possible in principle, but it is not a simple bolt-on conversion. The sweeper is part of Kubota’s front...

Thanks… Actually have this document printed on my desk, just keep forgetting to take it home!

KX057 isn’t very likely to fit into dump trailer unless it’s very big with heavy axes. Even if you can actually get it in the dump trailer, most likely you won’t get the balance right.

Yes! That is my concern. The existing female coupling (on excavator) doesn’t have a taper for the adapter to seal to. The flat face connectors I have are #10 ORB.

Ok, this is what all the BSPP fittings I found look like. I would expect a ORing on both sides of fittings not just one to get a good seal. What am I missing? https://www.discounthydraulichose.com/9006-10-08-10-saeorb-male-x-12-bspp-male.html

Thanks for collective wisdom, I appreciate the responses. I will check on BSPP fittings. I was going to mount the flat face connector to the silver adapter on the pipe. Rational is that we have a lot of invasive pepper trees and the fear is a branch may rip the coupling and more parts between...

Thanks for that, I have the same questions.