Recent content by eod99

Here are two I found concerning the front block

Ok as fast as I get back to book I will do that, thank you........

So my wsm has nothing on third function valve is there a service manual for third function. Once I release pressure I am guessing it released valve, since originally my grapple wasn't working if I hook it back up should operate like designed now

Ok tractor has no rear remotes. I checked quick couplers where grapple plugs in I manually pushed both check balls in fluid released outta both and now fel works like it should. 3pt lever is not pinned all the way up. Thanks for advise, is there a schematic of this hydraulic system that has...

I have a MX5800 HST 1089hrs, has Kubota 3rd function. I was removing my grapple to install pallet forks and noticed my grapple would not open, and like everything around here no time to diag had to load trailer. So I put forks on loaded trailer and as I finished I noticed my fel was going...

Absolutely not, I have 3 years on warranty and 2 years on insurance left not happening

Yeah I believe its a ring or valve issuse. Kubota swears it's 1st one they ever heard of. I believe they trying to get out of warranty but with Kubota insurance and warranty I'm not going to stop until they fix or replace it

The hills are 15 to 20 degrees and I change direction every lap, just seems odd my carb kawasaki on 54 inch kubota never used drop in 4 years on same hills

But would this cause oil burning?

I have a 781 with kawasaki fuel injected engine with 250ish hours burning oil. Approximately 1qt between services, no leaks but I do see blue smoke at times from exhaust. Dealership is saying that my hills are to steep and causing it to burn oil. The hills in question are about 20 degrees is...