eod99's latest activity

  • E
    eod99 reacted to TheOldHokie's post in the thread MX5800 FEL slow with Like Like.
    I was sure you would be :) Dan
  • E
    eod99 replied to the thread MX5800 FEL slow.
    That is extremely helpful and I greatly appreciate it, I will print this and add it to my collection. And yes I will be back with more...
  • E
    eod99 reacted to TheOldHokie's post in the thread MX5800 FEL slow with Like Like.
    There are no dumb questions. Kubota tractors have open center hydraulic systems. In an open center system the valves are plumbed in...
  • E
    eod99 replied to the thread MX5800 FEL slow.
    So here's a dumb question, I looked at complete section of the WSM manual and it does not go in depth about the fel, but gives test...
  • E
    eod99 reacted to TheOldHokie's post in the thread MX5800 FEL slow with Like Like.
    Here is the updated schematic showing loader and third function valves. Note that the hydraulic outlet block off plate has been replaced...
  • E
    eod99 reacted to TheOldHokie's post in the thread MX5800 FEL slow with Like Like.
    Thats good. I will add the loader and 3rd function circuits to the schematic. Your operators manual describes the use of the outlet...
  • E
    eod99 replied to the thread MX5800 FEL slow.
    Here are two I found concerning the front block
    • 20260404_234426.jpg
    • 20260404_234144.jpg
  • E
    eod99 reacted to TheOldHokie's post in the thread MX5800 FEL slow with Like Like.
    You are welcome. I was impressed you knew how to test the cylinders. You are definitly not a hydraulic dummy :) Read the description...
  • E
    eod99 replied to the thread MX5800 FEL slow.
    Ok as fast as I get back to book I will do that, thank you........
  • E
    eod99 reacted to TheOldHokie's post in the thread MX5800 FEL slow with Like Like.
    Your third function is just a single dpool AUX valve fed by the PB port on the loader valve. It in turn feeds the 3pt valve. Pencil it...
  • E
    eod99 replied to the thread MX5800 FEL slow.
    So my wsm has nothing on third function valve is there a service manual for third function. Once I release pressure I am guessing it...
  • E
    eod99 reacted to TheOldHokie's post in the thread MX5800 FEL slow with Like Like.
    Get a copy of the WSM. It has detailed information on the hydrauluc system but you have to "think your way" to diagnostic procefures...
  • E
    eod99 replied to the thread MX5800 FEL slow.
    Ok tractor has no rear remotes. I checked quick couplers where grapple plugs in I manually pushed both check balls in fluid released...
  • E
    eod99 reacted to North Idaho Wolfman's post in the thread MX5800 FEL slow with Like Like.
    First thing to check is any quick disconnect on the loader connections. Second thing to check is that the three point is not is the...
  • E
    eod99 posted the thread MX5800 FEL slow in Tractor Operating.
    I have a MX5800 HST 1089hrs, has Kubota 3rd function. I was removing my grapple to install pallet forks and noticed my grapple would not...
Show older items
Top Bottom