Elliott in GA's latest activity
-
Elliott in GA replied to the thread Has anyone found a BH77 Seat Cover?.FWIW, I contacted Cover Craft about a seat cover for my LX2610 SU (they have covers for the non-SU models with the better seat, the SU... -
Elliott in GA replied to the thread Rubber or Chain guards on Rotary Cutter.I would think either would be fine. I have an RCR 1860 with rubber, and after 4 years and reclaiming 12+ acres of really overgrown...
-
Elliott in GA replied to the thread Hard starting LX2610.First, I am not a mechanic; however, I doubt your glow plugs are the source of your problem. I would think that a glow plug problem...
-
Elliott in GA replied to the thread Hard starting LX2610.Just to cover some basic questions. Did you change the fuel filter at 50 hrs? When you say the fuel level was at 2 bars, how long was...
-
Elliott in GA replied to the thread Slip clutch.For a different perspective, I have a slip clutch on my rotary cutter (LP RCR1860), and it has been great. In over 4 years of...
-
Elliott in GA replied to the thread Securing factory warranty when buying from private seller.From the Kubota Warranty Guide: Transferability If you decide to sell your Kubota, any remaining warranty coverage may be transferred...
-
While I have no specific data on tip over angles, I will throw out this, for what it is worth. In my rock crawler days, dashboard...
-
Elliott in GA replied to the thread L vs LX.FWIW, since you do not need a mid-PTO, the LX SU does not have a mid-PTO or the upgraded seat (plus some other small items - the seat...
-
Elliott in GA replied to the thread Pneumatic Vs Cordless.I was looking at Torque Multipliers, before I bought the Ryobi that I posted above. A decent one, like the Neiko Pro, was the same cost...
-
Elliott in GA replied to the thread Pneumatic Vs Cordless.DeWalt 899, Flex and Milwaukee tested on Torque Channel. Like all tools, you see the difference between claimed and real world.
-
Elliott in GA replied to the thread Pneumatic Vs Cordless.For the money and the power, I bought the Ryobi 1/2 inch impact wrench. If you use a 6 Ah or above battery, you will have 700+ removal...
-
Elliott in GA reacted to Cody Dellinger's post in the thread Grapple options for the L2501/LA525 with
Like.
As the Vice President and a second-generation leader at Catawba Attachments (EWI Fabrication & Manufacturing) , I want to clarify that... -
Elliott in GA replied to the thread Thoughts or advise.Obviously, wear gloves. These are the best that I have found to prevent punctures and cuts with good dexterity and not hot...
-
Elliott in GA replied to the thread Gloves.Amazon - I am sure that there are other sources. With Amazon (as always), choose carefully to ensure you are getting actual Hex Armor...
-
Hexarmor are great- I really like these (have a set I've used for 3 years just starting to wear out)...