Recent content by edandlisa1999

  1. E

    Loader SLOOOOW

    If it follows the hoses I wouldn't think it would be the Valve,,,,Correct?
  2. E

    Loader SLOOOOW

    Yes it does lock in float
  3. E

    Loader SLOOOOW

    Yes it does lock in float
  4. E

    Loader SLOOOOW

    Yes it does have bolts to stop lever but I have tried adjusting them with no effect
  5. E

    Loader SLOOOOW

    Swapped hoses around and it did follow the hoses,,,now the bucket curl is slow
  6. E

    Loader SLOOOOW

    Not sure on model but tractor is a 1989 and I believe loader was bought at same time. Driven by pump on side behind injector pump Single lever 3 lines of valve besides lines going to cylinders Has a float position Thanks
  7. E

    Loader SLOOOOW

    Thanks for the reply. I haven't noticed any squealing or engine bogging down
  8. E

    Loader SLOOOOW

    I have a B8200 HST with loader that I am having some issues with. The 3pt works perfect and loader works perfect with this exception, When I raise the loader it goes up Extremely Slow but all other function work fine even the down pressure will lift tractor off ground. In my trouble shooting I...
  9. E

    Hydraulic remotes

    I have a B8200 HST with loader that I am having some issues with. The 3pt works perfect and loader works perfect with this exception, When I raise the loader it goes up Extremely Slow but all other function work fine even the down pressure will lift tractor off ground. In my trouble shooting I...
  10. E

    B8200 Loader operation

    Yes rear hydraulics work fine, fluid level good. I chained the rear hydraulics down and then pulled the lift lever for rear,,,then it appears the hydraulics were transferred to the loader and it operated as it should,,,,,With that said do you think that the Directional Valve is bad? If so can it...
  11. E

    B8200 Loader operation

    Mine looks like your picture except the roll pin has been broken off. I kept turning the knob while operating the loader and finally the bucket starts curling just fine but the lift still is not working unless I raise the rear hydraulic at the same time.
  12. E

    B8200 Loader operation

    Not sure if this might be the problem but the roll pin has been bent and the hex nut/valve will spin completely now around,,,could be problem but do not know how to adjust position now
  13. E

    B8200 Loader operation

    Just bought a 1989 B8200 with loader. The Loader won't operate unless I move the rear hydraulic lever at the same time I move front hydraulics for loader,,,Any thoughts would be greatly appreciated
See more
Top Bottom