Recent content by Earl W

  1. E

    ZD326 starter problems

    Thanks, I can check the switch after the Hurricane blows past. Frame ground is good, tested when I replaced the battery ground cable and retested it as part of the debugging process. Thanks! I was afraid I might have to get a starter assist relay. The heat shield makes sense, I had never...
  2. E

    ZD326 starter problems

    Having challenges getting the beast to crank/turn over when cold. If I am lucky, every once in a while it will turn over when hot, but not often. I have read the threads I can find but have been unable to solve the issue. The battery new and good with clean terminals, it turns over and starts...
  3. E

    ZD326 stalling after cutting for 15 min

    Sorry it took a while to get back. After confirming I was set to the left tank, I disconnected the fuel line where it goes into the injectors and confirmed there was very little flow. After confirming that, I re-attached it. Then I took the black covers off the left tank and pulled out the...
  4. E

    ZD326 stalling after cutting for 15 min

    Looking for help with my ZD326 which has approx 1500 hours on it. After cutting about 15 min or 1/3 acre, it starts loosing power and stalling if you do not stop forward motion, stop the blades and reduce throttle to very low. Then, if your lucking, you can creep back to the barn then. Seems...