Recent content by e dogg

Ill also add here that the RCK60-30BB fits the B23650 without any mods or extra parts to buy

It turned the few hour job into a whole day job, thats for sure! I about had a heart attack when I went to put the lift mechanism bushings (90 and 100 in the diagram above) on the 3 point hitch shaft , as there isn't enough clearance to drop them between the ends of shaft and BH77 frames. I was...

Did this solve your issue Jasonc?

Ended up getting a new one from a local dealer.

Update: I ended up having to move the backhoe frame, mercifully it can be unbolted and rotated out of the way without removing the rear wheel. Unclear still if the 'passenger' side frame will need to be moved on the same way. I'll post again tomorrow once I get back at it.

I just made a post asking if there is a secret method to get that carrier shaft to slide in (#50 in 2nd pic), because the backhoe frame is in the way... Looks like the secret is there is no shortcut and that frame has to come off, ouch!

I bought a used B2650- with Backhoe and FEL. I just picked up a RCK60-BB (multiple dealers said this is the same item as RCK60-BA with a new Part #). The 'rear hanger shaft' is supposed to slide through holes in each side of the frame, but the outer orange frame is interfering. There is a notch...

I have a big koi pond to dig, and some misc trenching will come up every few months, so I prefer to own instead of rent. Where I live the rental market is iffy, ive had places cancel reservations several times.

They are common in aftermaket automotive, such as oiling systems for upgraded turbos, or fuel connectors. AN are more common, but they are more expensive.

Thanks Matt!! One of my fittings was just finger loose, so I shut off the machine and tightened it. I could only get a regular line wrench onto it so i just was gentle. I am pretty experienced wrenching on cars, which use JIC as well. what do you think of these? Obviously these cant handle...

Thanks for the info. I should have mentioned i could barley tighten the fitting due to the limited arc of the wrench due the othe fitting on either side, not because I was applying ape torque.

I just purchased a B2650 with BH77, and noticed a leak where the hard lines connect to the valve body. I could barely tighten it with a standard line wrench. Are there better tools out there for these fittings? I am what people may refer to as a tool whore, in other words I prefer to have high...

Local dealers in GA all told us that adding BH77 can add 9+ months to the wait for an LX. We ended up getting a used B2650 with a backhoe instead, holes need to be made now!

I know its been a while, do you still have this?

Finally found a B2650HSDC with a BH77 and FEL, and am now looking for a belly mower. We use a cyclone rake in fall so a 3 point finish mower wouldn't quite work for us. Willing to pickup within few hundred miles of metro Atlanta area, or pay for freight.