Recent content by dwwright

not starter but ignition switch

I think you must have mis-understood me somewhere. No fuses are blown! So far I have replaced the seat switch, starter relay which checked the same as new one with ohm meter unconnected, pto switch which checked bad, and starter. Still no voltage to injector silinoid. I really need to know where...

I called the kubota place and was told that this part was a starter relay switch.

Hmm, I may have found the problem. Under the dash, out of sight is what appears to be some sort of fusable link. 12v-A-5. It has four prongs in it. Two on left side looks like brass, two on right side looks like copper.Two on left side has 82.3 ohms. Two on right side is open. no continuity...

Hmm the only fuse panel I see is on the left side . All fuses checked out ok. Removed them and checked them with meter just in case my old eyes were deceiving me. will the safety switches prevent voltage from going to pump or do they simply controll starter? I'm thinking seat switch must go to...

304.8 hours on hour meter. I checked all fuses on left side fuse box, all good. I also took off fuel pump selenoid to friends house and hooked to his tractor and it worked. I did this just to be sure that it was not the problem

I have a Mx5000su that is not pumping fuel. I replaced the switch under the seat. When I turn on the key it does not click like it does on my friends tractor. The motor turns on but injector pump does not pump fuel. If take of the wire to pump selinoid and jump hot wire from batery to post on...